Search results

Clipper Mode<br> Clipper Mode cancels, &amp; is cancelled by, Rotate, Move/Resize, &amp; Translate M

== The Clipper Tool, Cutting & Splitting Brushes == ...new brush in the gap but instead let's use this opportunity to explain the clipper tool...

...r Full Guide Page 3#The Clipper Tool, Cutting & Splitting Brushes|Brushes, Clipper, cutting, dividing]]<br> ...Z Beginner Full Guide Page 3#The Clipper Tool, Cutting & Splitting Brushes|Clipper, cutting, dividing brushes]]<br>

Once the stairs are as high as necessary, use the clipper to delete the un-required part of each step. In the example below, only a f ...goes anticlockwise from the floor, and you'll notice that the 0 - 1 of the clipper also goes anticlockwise. Pressing Enter deletes the lower part of the brush

...s not hard to figure out though so take a shot. Create a brush, choose the clipper tool and click two places on the brush, all you are doing is drawing a line ...nd drag it changing the angle of the cut. At any time you can unselect the clipper tool and your brush will NOT be cut.

...pper tool does not use caulk. Switch to the top-down orthoview and use the clipper tool to cut this brush up into blocks so that you get a grid. A good size w ...the mansion in the image, then enable the filter for entities and use the clipper to remove those parts of the monsterclip brushes that overlap with the hous

...south east clipping through the south wall of our upstairs room so use the Clipper tool to cut it away. To do this... # Select that wall and using clipper (X key) click on it left and right between floors and use Shift + Enter to

* "X" go into clipper mode. ...the walls of a multi-sided brush to line up seamlessly is still to use the clipper-tool and precisely cut off a slice. (And don't use CSG Subtract unless you

| Creating your own prefabs, adding hallways, using layers, using the clipper tool to cut doorways, creating brush trim, copy/paste shader tool ...doors by using prefabs, vertex editing mode, cutting brushes along lines (Clipper mode), building corridors, using the 3D view, creating entity light

* Select the clipper tool (see [[Dark Radiant Controls, Keys & Mouse|DR Controls]] for details)

* Press {{key-ctrl}}+{{key|name=X}} for ''Clipper'' or select [[Image:DRclipper.jpg]] on the left toolbar

More complex multi-brush doors can be created using the [[Clipper]] tool, CSG, etc. - this is not covered in this tutorial. Then assign <code