Adding Offset Values for Specific AI: Difference between revisions
From The DarkMod Wiki
Jump to navigationJump to search
Springheel (talk | contribs) No edit summary |
(formatting) |
||
| Line 1: | Line 1: | ||
All EntityDefs have two values-- | All EntityDefs have two values -- an Offset value that determines their position relative to their attached joint, and an Angle value that determines what angle they're at. | ||
The default values for these do not always work ideally for every AI, so it is possible to edit the | The default values for these do not always work ideally for every AI, so it is possible to edit the entityDef to give values for specific AI. | ||
It would look like this: | It would look like this: | ||
entityDef prop_helmet_test { | entityDef prop_helmet_test { | ||
"inherit" "func_static" | "inherit" "func_static" | ||
"model" "models/darkmod/props/kitchen/chamberpot.lwo" | "model" "models/darkmod/props/kitchen/chamberpot.lwo" | ||
| Line 14: | Line 14: | ||
'''"angles_atdm:ai_builder_guard" "0 0 0"''' | '''"angles_atdm:ai_builder_guard" "0 0 0"''' | ||
"remove" "0" | "remove" "0" | ||
} | } | ||
[[Category:Tutorial]] | [[Category:Tutorial]] | ||
[[Category:Editing]] | [[Category:Editing]] | ||
Revision as of 01:23, 23 January 2007
All EntityDefs have two values -- an Offset value that determines their position relative to their attached joint, and an Angle value that determines what angle they're at.
The default values for these do not always work ideally for every AI, so it is possible to edit the entityDef to give values for specific AI.
It would look like this:
entityDef prop_helmet_test {
"inherit" "func_static"
"model" "models/darkmod/props/kitchen/chamberpot.lwo"
"joint" "Head"
"origin" "2 -10 0"
"angles" "10 190 80"
"origin_atdm:ai_builder_guard" "0 0 20"
"angles_atdm:ai_builder_guard" "0 0 0"
"remove" "0"
}
