Texture Tool Example 01

Back to Texture Tool

Introduction

In this patch example there is a sloping chimney above a fireplace. This is made of brushes (with narrow patch bevels to soften the edges.) You can see from the image on the right that the texture on the slope pointed to by the yellow arrow aligns at the base of that slope with the front surface of the chimney on the left. But higher up the slope it does not align (indeed cannot, with a brush except perhaps with a custom texture.) If you scroll the texture along to align the top then it will not align further down.

To fix this I retextured the sloping surface with caulk and placed a patch exactly over it with the required texture. I aligned this with the texture below that slope to start with in the normal way (using copy shader then paste shader natural.) With the patch selected I used the texture tool, selected the top row of vertices and LMB dragged sideways to the point where the texture just to the left of the edge matched (actually the edge bevel in this case but it would be the same for just a brush edge.) I kept the top vertex line horizontal. DeSelect and the result is a perfect match as you see in the image on the right.

Here are the step by step details...

Step by Step Alignment

placeholder for Texture Tool Example 01

TEXT TO BE ADDED LATER

note to self : check out MMB options

TEXT

TEXT

TEXT

TEXT

TEXT

TEXT

TEXT

TEXT

TEXT

TEXT

TEXT

TEXT

TEXT

TEXT

TEXT

TEXT

TEXT

TEXT

.......