Patch Troubleshooter: Difference between revisions
From The DarkMod Wiki
Jump to navigationJump to search
New page: ==Introduction== This article is about how to fix various errors and problems you might encounter with patches ==Patch alignment error== How do you deal with this problem where two curv... |
|||
Line 1: | Line 1: | ||
==Introduction== | ==Introduction== | ||
This article is about how to fix various errors and problems you might encounter with patches | This article is about how to fix various errors and problems you might encounter with patches | ||
==Patch alignment error== | ==Patch alignment tessellation error== | ||
How do you deal with this problem where two curved patches will not align? | How do you deal with this problem where two curved patches will not align? | ||
Revision as of 12:48, 1 April 2008
Introduction
This article is about how to fix various errors and problems you might encounter with patches
Patch alignment tessellation error
How do you deal with this problem where two curved patches will not align?
The problem is caused by the number of sections in each patch not matching, ie, it's the "Tesselation" of the patch curve. In many cases such as that one where you are matching up a cap or flat top curve with a vertical wall patch that bends, you will want to set them both to "Fixed Subdivisions"
- Select one of the patches
- Open the "Patch Inspector" by pressing "Shift+S"
- Near the bottom check the box next to "Fixed Subdivisions"
(You should suddenly see the patch go somewhat "square")
- Experiment cranking up the Horizontal or Vertical number until you get desired curvature
- Repeat steps for the matching patch and set either Horizontal or Vertical to the same number.
(In the second patch it may not be the same Horizontal or Vertical, i.e. it could be the opposite)