BindOrientated - Revision history

Fidcal: /* Examples */

2009-04-25T06:45:34Z

Examples

← Older revision		Revision as of 06:45, 25 April 2009
Line 5:		Line 5:
	== Examples ==		== Examples ==

	With bindOrientated 0, a shaft with its origin at one end attached to a rotating axle with [[bind]] will move up and down and back and forth like an old steam locomotive shaft attached to a drive wheel. With the default bindOrientated 1, the entire shaft would rotate around the axle like a spoke.		With bindOrientated 0, a shaft with its origin at one end attached to a rotating axle with [[bind]] will move up and down and back and forth almost like an old steam locomotive shaft attached to a drive wheel. With the default bindOrientated 1, the entire shaft would rotate around the axle like a spoke. Note that there is only one attachment point. If the shaft starts horizontal then it remains horizontal but moves around in a circular motion.

	{{spawnargs}}		{{spawnargs}}

Fidcal: /* Description */

2009-04-25T06:42:47Z

Description

← Older revision		Revision as of 06:42, 25 April 2009
Line 1:		Line 1:
	== Description ==		== Description ==

	The [[spawnarg]] ''bindOrientated'' if set at 0 causes the [[entity]]'s origin (only) to rotate around a rotating entity if attached to it with [[bind]] instead of the entire entity.		The [[spawnarg]] ''bindOrientated'' if set at 0 causes the [[entity]]'s origin (only) to rotate around a rotating entity if attached to it with [[bind]] instead of the entire entity which always remains pointing in one direction.

	== Examples ==		== Examples ==

Fidcal: /* Examples */

2009-04-25T06:31:08Z

Examples

← Older revision		Revision as of 06:31, 25 April 2009
Line 5:		Line 5:
	== Examples ==		== Examples ==

	A shaft with its origin at one end attached to a rotating axle with [[bind]] will move up and down and back and forth like an old steam locomotive shaft attached to a drive wheel.		With bindOrientated 0, a shaft with its origin at one end attached to a rotating axle with [[bind]] will move up and down and back and forth like an old steam locomotive shaft attached to a drive wheel. With the default bindOrientated 1, the entire shaft would rotate around the axle like a spoke.

	{{spawnargs}}		{{spawnargs}}

Fidcal: New page: == Description == The spawnarg ''bindOrientated'' if set at 0 causes the entity's origin (only) to rotate around a rotating entity if attached to it with bind instead of the e...

2009-04-25T06:27:06Z

New page: == Description == The spawnarg ''bindOrientated'' if set at 0 causes the entity's origin (only) to rotate around a rotating entity if attached to it with bind instead of the e...

New page

== Description ==

The [[spawnarg]] ''bindOrientated'' if set at 0 causes the [[entity]]'s origin (only) to rotate around a rotating entity if attached to it with [[bind]] instead of the entire entity.

== Examples ==

A shaft with its origin at one end attached to a rotating axle with [[bind]] will move up and down and back and forth like an old steam locomotive shaft attached to a drive wheel.

{{spawnargs}}